Mercedes Sprinter Right Front Brake Caliper – Brembo | VS30 1500 / 2500 / 3500XD | #9074219000 (2019–2024)

A seized or leaking right front brake caliper on a VS30 Sprinter creates an immediate and serious safety hazard — dragging brakes on the front axle generate dangerous heat, cause the van to pull hard to the right under braking, and destroy pads and rotors on the affected corner in a fraction of their normal service life. This is the Brembo right front brake caliper for VS30 Sprinter 1500, 2500, and 3500XD models, a direct replacement that restores proper front brake clamping force, release, and balanced braking across the front axle.

What This Part Does

The front brake caliper is a hydraulic clamping assembly that mounts to the steering knuckle and straddles the front brake rotor. When the brake pedal is pressed, hydraulic pressure from the master cylinder and ABS module pushes the caliper piston outward, clamping the brake pads against both faces of the rotor and generating the friction that slows the front axle. On the VS30's front axle, the caliper operates at higher hydraulic pressures and generates more braking force than the rear calipers — front brakes typically handle 60–70% of total braking effort. When the caliper's piston seal fails and allows fluid past, the piston sticks in the extended position, dragging the pads against the rotor continuously and generating the heat, pull, and smell that signal immediate attention.

Common Symptoms of a Failing Front Brake Caliper

• Vehicle pulling strongly to the right during braking
• Right front brake pads wearing significantly faster than the left
• Heat, burning smell, or smoke from the right front wheel after driving
• Brake pedal that feels spongy or requires more travel than normal
• Brake fluid leaking from around the caliper body or at the brake hose connection
• Grinding noise from the right front corner from pads worn through on a dragging caliper

When to Replace

Replace when the caliper is confirmed seized, leaking, or unable to retract properly after brake service. Always replace front calipers in pairs — left and right — to maintain even braking balance across the front axle. Replace brake pads and inspect rotors at the same time, and bleed the brake system after installation.

VS30 Specific — VIN Verification Required

This is the right front caliper for VS30 Sprinters (W907/W910). It does not fit NCV3 Sprinters (2007–2018). Left and right front calipers are not interchangeable. Always verify by VIN before ordering. Contact us and we'll confirm fitment before you buy.

Fitment

• 2019–2024 Mercedes-Benz Sprinter 1500 – Front Right, RWD & AWD (VS30)
• 2019–2024 Mercedes-Benz Sprinter 2500 – Front Right, RWD & AWD (VS30)
• 2019–2024 Mercedes-Benz Sprinter 3500XD – Front Right (VS30)

✔ Right (passenger) side only — left side requires a different part number
✔ Does NOT fit NCV3 Sprinters (2007–2018)
✔ Replace in pairs with left front caliper for even braking balance

Part Numbers

• Mercedes OEM: 9074219000 / A9074219000 / 907-421-90-00
• Manufacturer: Brembo
• SKU: 9074219000